Cummins Adblue- NOx Emulator 

The adblue emulator allow to disable SCR system on trucks for Cummins engins and system Emitec, Grundfos and for BOSCH . not need computer programming, it is a plug and drive 

For trucks

- for DAF LF

Chinese trucks:

- for CAMC

- for FAW

- for AVIA

- for HAGER

- for KINGLONG

- for YOTONG

Vehicle list ( not need computer programming )

ISG12 Euro IV/V

ISF3.8 for Light Commercial

ISF2.8 for Light Commercial

ISMe for Euro Truck & Bus

ISL for Euro Truck & Bus

ISB6.7 for Euro Truck & Bus

ISB4.5 for Euro Truck & Bus

ISL G for Euro Truck & Bus

B Gas Plus (Euro 5)

C Gas Plus (Euro 3 & 4)

ISB5.9 G for Euro Truck & Bus

for Cummins Adblue / NOx Emulator Installation

Turn off the truck\'s ignition before starting the installation FOR Cummins emulator.

Replace the dosing pump is of the socket on the emulator to the level of UREA tank you see in the imagebelow.

Insulate the connector of the dosing pump for the dosing pump to be idle socket.

Check the level indicator in the vehicle after making assembly of the dosing pump  emulator will show 50% or 75% ratio of level.

After installation is complete,go to the level sensor assembly of  the NOx sensor emulator.

Disconnect the NOx sensor connector shown below and connect  the AdBlue emulator tool

Insulate to get water to be idle socket of the NOx sensor.

After installation is complete, go to the  level sensor assembly of  the NOx sensor emulator.

Disconnect the NOx sensor connector shown  below and connect the AdBlue emulator tool. 

Insulate to get water to be idle socket of the NOx sensor.

Run the truck.When you see no fault in the truck\'s dash lights burning installation process is completed.

Insurance except as described herein pull cord cutting,etc.Style,nothing is done

Emulator works with plug and play system.

Packing list :

- For Cummins adblue emulator

- euro3 nox socket 

- euro4 nox socket 

- adblue socket